Skip to main content
PoolBoss

The Route

Pool equipment and repair guides - page 2

Diagnose pumps, heaters, and filters, and quote the repair.

Overhead view of a pool skimmer crossing clear water beside a stone pool edge

Updated

Pool pump troubleshooting on the route

A pool pump usually will not prime for one of four reasons: the water level has dropped below the skimmer mouth, a strainer basket or impeller is clogged, the pump lid O-ring has failed, or a suction-side fitting is drawing air. Bubbles still swirling in the basket after 30 seconds mean air is getting in, not purging out.

Read the guide

Updated

Pool heater troubleshooting: the service-call guide

Most often the heater is not getting enough water flow, usually from a dirty filter or clogged baskets rather than a gas fault. The other common causes are gas supply problems, a failed igniter or gas valve, a dirty flame sensor, and blocked airflow or venting. Controllers typically lock out after 30-60 seconds of failed ignition attempts.

Read the guide

Updated

Solar pool heating: what to tell customers

It is worth it when the customer has the unshaded area for panels and wants a longer season rather than heat on demand. Solar costs the most up front and effectively nothing to run, with payback commonly inside about seven years. A heat pump wins when the heat has to arrive on a schedule.

Read the guide

Updated

Pool filter repair or replace: making the call

Repair it when the failure is a seal, gasket, gauge, or valve part and the tank itself is sound and under about ten years old. Replace it when the tank is cracked, the same internals have failed twice, or the repair costs more than about half a new filter.

Read the guide

Updated

The equipment walk-around at every stop

Check five things at every stop: water level, the skimmer and pump baskets, filter pressure against that pool's clean baseline, visible leaks or drips at the pad, and whether the equipment is actually running. The value is not the glance. It is recording the same readings the same way each visit so a trend shows up before a failure does.

Read the guide

Updated

Variable-speed pumps: the recommendation that pays back

Recommend one when the pool runs a long season, the existing pump is an oversized single-speed, or the local utility rebates it. Typical savings run 50-70% against a single-speed and payback is commonly about two years. Skip it on a short-season pool that already runs only a few hours a day.

Read the guide